Instructions / Assembly

1. Remove the old toilet
and the old wax ring
with the putty knife.
2. Clean the closet ange
thoroughly so there is
no leftover residue.
NOTE: The existing
closet ange
may be used in
this new toilet
installation,
or you may
purchase and
install a new
closet ange.
3. Dry t the drain socket
ange (using the existing
bolts in the closet
ange) and position it so
it is straight.
4. Mark the position of the
pilot holes for the drain
socket mounting screws
at the rear of the drain
socket ange. (You will
mark 4 holes in total.)
(See Illustration A)
5. Remove the drain
socket ange and drill
the 4 pilot holes. Insert
the anchors into the
pilot holes.
6. Fit the drain socket over
the closet ange, using
the existing bolts, or
you may purchase new
bolts.
7. Secure the drain socket
with the washers and
mounting screws.
8. Dry t the toilet.
9. Use tape to mark the
edge of the toilet skirt
directly below the
mounting holes on each
side of the toilet (these
marks will be used to
measure the placement
of the L-mount
brackets).
10. Also mark the center
edge of the front of
the skirt with tape (this
mark will be used for
placement of the toilet
later in the installation).
11. Remove the toilet.
NOTE: The center of
the drain socket
ange must be
aligned with the
center of the
closet ange.
(Clogging may
occur if the
drain socket
is attached off
center.)
NOTE: Do not install
the new wax
ring in this step.
POSITIONING OF THE DRAIN SOCKET FLANGE
INSTALLATION
PAGE 4