STEAM BATHROOM MODEL : WS-701 Your best choice! No advanced advice will be submit before we change our design and size. The pictures may be a little different from the real products. Our company keep the final explanation right.
TECHNIQUE PARAMETER Vol tage Ac 110 V( ±10%) Water Volatge Freque ncy 60H Z 0.1~0 .2M pa Power of steam generator 2.65K W Power of water pump 1.2H P Power of heat pump 1.0K W Power of air pump Storage capacity Storage capacity 0.2K W 66g al lon 0.3m 3 Self-clean system Step 2 Step 1 CAUTIONS: Heat pump and air bubble pump is required by customers.
Packing list Packing 1 Packing 2 Spare parts list 13 CONSTRUCTION SKETCH four pieces of glass shower body, four pieces of fixed glass door , two pieces of sliding glass door ,one piece of post,two pieces of decorating post,two pieces of magnetic strip,four pieces of water resist strip,six pieces of single side plastic seal, two pieces of up and down bended aluminum column,two pieces of decorating board.茎 one tray,one roof, two pieces of long handle.
ATTENTION 150 ″) (5.9 The socket of power and the socket of telephone Cold water pipe Hot water pipe 620(24.4″) 2250(88.6″) INSTALLATION SKETCH 1800 (70.8″) 1250 (49.2″) 53 4″ ) 29 ″) ″) 0 (1 Other screws 5. M4x16 M4x25 ) 4″ 1. (6 29 1 0( ″) 60 60 .4 1 .4 0.9 16 16 5 (6 0(2 Install the screw M6x25 1.In order to be tripped and fell down, pay more attention when get into the steam room. Please don't shut the finger in the door in order to be hurt. 2.
Attention: The machine must be fixed in the circuit which protected by creepage protectionand should be well-connected with the ground. Nontechnical people can not be fixed or removed at random. INSTALLATION PROCESS 1.Assembly of tray If the ground is not smooth,please adjust the nail under the tray to keep the balance of the tray and ground. STEP1 6、Technical parameter Voltage Current KL-824 110V Top light 20W Sidelight 5W 25A Fan 3.
M4x1 2 4. Assembly of fixed glass door Connect the fixed glass door. STEP4 Active chain wheel of glass 5. Assembly of sliding door put the sliding door into the up and down aluminum track to keep it balance,fix it. STEP 5 M4x20 6. Install the shower body Put the glass door on the tray, together with the back shower body,fix it. (2) The application of the back lamp Press ,the sidelight is on. Press again, the ceiling lamp is out, press a third press, the sidelight is out too.
. Install the roof Put the roof onto the top of shower body,then fix tightly with bolts. 1 4 2 5 3 6 M4x20 7 8 C STEP7 8. Install spare parts A. Finish assembling the whole set,in order to aviod water and steam leaking,except the position of sliding glass door do not use the silicone, the silicone should be used on all else connecting position . B. While connecting the cold water pipe and drain pipe ,wipe the silicone on the connecting mouth to make it will be connected very well. C.
DRAWING OF WATER CONNECTION As the“ ” “ ”from the picture,please make the connection according to the serial number v1,v2,etc.