Installation Guide

P 1

WWW.ARIELBATH.COM

Need Further Assistance?

For more help, please contact us and one of our trusted

experts will be more than happy to provide guidance.

800-509-5070

Monday - Friday

9:00am - 5:00pm (PST)

UNDERMOUNT SINK INSTALLATION GUIDE

Base cabinet

Countertop

Sink basin

Backsplash

INCLUDED

Hardware

Permanent marker

Silicone - (Recommend Liquid

Nails #LN-933 OR Loctite

#PL530 OR GE Silicone II #M90010)

Epoxy - (Recommend Loctite

#1365868 OR Gorilla Glue #4200101)

Caulking gun

NEEDED HARDWARE

STEP 1 - PLACE & TRACE

Place the sink basin on the bottom of the countertop, making

sure to center over the opening. Draw guide lines on the

countertop and the basin in two locations.

MARKER

STEP 2 - PREPARE SINK BASIN

Using a caulking gun, apply a heavy amount of silicone of your

choice on the top side of the sink basin edge.

SILICONE

STEP 3 - FLIP & SET IN PLACE

Carefully ﬂip the sink basin over and place it so the guide lines

match up in both locations.

STEP 4 - DRY & SET

Press down on the sink basin to seal the silicone. Remove any

excess. Follow dry time recommendations found on your

product, typically 12 to 24 hours.

Bolts (4) Undermount clips (4)

Washers (4) Wing nuts (4)

PAGE 1
UNDERMOUNT SINK INSTALLATION GUIDE INCLUDED Base cabinet Countertop Sink basin Backsplash Hardware NEEDED HARDWARE Permanent marker Silicone - (Recommend Liquid Nails #LN-933 OR Loctite #PL530 OR GE Silicone II #M90010) Epoxy - (Recommend Loctite #1365868 OR Gorilla Glue #4200101) Caulking gun A B Bolts (4) C D Washers (4) MA RK ER SIL I CO Undermount clips (4) Wing nuts (4) NE STEP 1 - PLACE & TRACE Place the sink basin on the bottom of the countertop, making sure to center over the openi
PAGE 2
EPOXY UNDERMOUNT SINK INSTALLATION GUIDE D A A C B STEP 5 - PREPARE & SET BOLTS Fill in the small holes surrounding the sink basin with epoxy. Immediately place the top of the bolt (PART A) in the hole with the epoxy. Allow sufficient dry time & follow the package directions on the epoxy before moving to the next steps, typically 12 to 24 hours.