USER'S MANUAL
CONTENTS Please read carefully before using SAFETY NOTICE Safety statement Installation and operation instruction The creepage overload protector should be installed in the power supply. The crust earth wire of the water pump should be well earthed. Trouble shootig It is forbidden to use the machine after having alcohol dring or hypnotic medicine. Maintenance The children should be accompanied by their parents when using the machine.
Illustration of the electric principle of massage bathtub Message bathtub water flow control principle illustration water pump crust cold water water fau power plug hot water shower head overflow outlet drawinage massage water pump hydro-massage water outlet nozzle4 hydro-massage water regulating switch M: massage water pump k: pneumatic switch Bk: transformer D: bottom lamp G1: the earth wire of water pump plug G2: the earth wire of water pump crust
Fittings explanation The operation instruction 1.A,B are cold and hot water control valves.They can be turned on at the same time to adjust the water temperature.Then B can be used to choose to use shower head(D) or water outlet(I). 2.J is pneumatic switch. It turned on/off the water pump and bottom lamp at the same time. When the water pump is turned on, hydro-massage water comes out from the nozzles (E). Water flows back through the net thus it begins to circulate.
Maintenance 1.Temperature 4.Prepare to use: The massage bathtub is suitable for water beow 80 C.When using it,turn on the cold water before turning on the hot water. Please make the water level reach normal height (usually 10cm higher than the nozzles), to prevent the pump from working without water. The direction of the nozzles can be adjusted to your mind. 2.Maintenance Maintenance of plated parts: Please use flannelet to rub them gently. Don't use rough cloth to rub them.
Tr o u b l e s h o o t i n g phenomenon reason 1.The steel stand under the bathtub is not balanced. The screws are not fastened. Violent vibration and too much noise 2. The fastening screw or the shockproof glue of the motor are incomplete or loose; 3. The water level does not reach the norm al height. 4. There is something with wrong the motor. The motor works normally but no water comes out from the nozzles or the water pressure is not high enough. 1. The not is partly jammed. 2.
The water pump installation 1) nut 2) connection tube ( 11/2"tube) 3) connection tube (1" tube) 4)&9)& 15) "O" shape ring 5) stainless steel bolt 6) stopper head 7) cover, the siphon, SB type 8) cover, siphon, SC type 10) impeller 11) airproof groupware 12) pump body 13) centrifugal 14) motor How to install and operate the water pump I.Dismantle The repair of the water pump should be done by professional worker. This instruction can help to repair and install the water pump.
5.Use 1/16 ball bearing and RTV sealing glue. The sealing glue should be 360 degrees in touch with the axis and the centrifugal oil ring. Keep the sealing glue for 15 minutes. 6.Install the crust (10). Screw down 4 inserting bolts. 7.Screw the impeller down to the axis. The axis cover pushes the certrifugal oil ring, which is sealed to the impeller by the RTV glue. 8.Install "O" shape ring (9) to the cover (7) (8). 9.Put the cover (7) (8) in position. Screw down 6 bolts (5). 10.