Self-clean system Step 2 Step 1 YH300 YH300A YH301 YH301A YH302 YH302A Pour into cleaning liquid from here Step 3 Step 4 Cleaning method： 1.Clean the steam engine regularly at least once by every 2weeks or after using 20 times. 2.Inject citric acid as main cleaning liquid,add 1.5L each time.after 10 minutes, turn on and When the system turns on, press“ button to start the steam function for about 30seconds and then shut down the system.After vent the stagnant water,repeat 2 or 3 times. 3.
Dear users: Thanks for choosing our products, for the purpose of safety, please read this manual carefully before use. The instruction manual be the same with the following steam room: YH300/300A YH301/301A YH302/302A Packing list Packing 1 two pieces of glass body, two pieces of fixed glass door, one piece of sliding glass door, two pieces of corner plastic seal , six pieces of water resist strip, two pieces of magnetic strip,two pieces of single side plastic seal .
Attention: The machine must be fixed in the circuit which protected by creepage protectionand should be well-connected with the ground. Nontechnical people can not be fixed or removed at random. 302/302A STRUCTURE SKETCH (Other models can refer to this model) 1 2 6、Technical parameter 8 Model Voltage Current KL-824 110V Top light 20W Sidelight 5W 25A Fan 3.
302/302A ACCESSORIES (Other models can refer to this model) (Plastic pad) (Connecting seal) (Connecting seal) (Glass door seal) (Pl a stic se a l) (Fixed glass door and sliding glass door) C 03 (1) The electrical pitch Press pitch can open the machine, the temperature is the room temperature.The time will show 30m. At the same time, it will open the ceiling lamp.Press again will close all the functions.
(Glass rack) 4 2 5 3 6 (A t BS op 7 8 ) (G as (S C C i (S 1 Time adjustment pitch+ 5 Temperature adjustment pitch- 2 Temperature adjustment pitch+ 6 Fan Pitch 3 CeilingLamp/Back Lamp pitch Steam Pitch 4 Time adjustment pitch- 7 8 de g s las go d y) k ) et e cr wM 6 0 X2 (N ut ) ) Main Cock Pitch (Nail) 11 (Hinge) (Hand-held shower) 1 YH302/A 04
THE DRAFT AND SIZE FOR THE DIFFERENT MODELS Hand-held shower Water and electric circuit sketch water inlet Model:YH301(clear glass) Model:YH301A(blue glass) Size:900X900X2150mm 1000X1000X2150mm 1.Adjust the tray to be horizontal by a horizontal meter. 2.Fasten the up and down nail (no space left), at the same time keep the back and side glass body vertical to the tray. 3.Fix the hinge onto the fixed glass door, make it be horizontal to the tray. 4.
4、Install the ri gh t body INSTALLATION PROCESS OF 302/302A (Other models can refer to this model) 1、Install the bottom tray: If the ground is not horizontal, please regulate the screw of the bottom tray , make the bottom tray and ground keep competence.
6、Install the ABS top (A t BS op (G k as ( i (S de g s las Model :YH302(clear glass) Modle : YH302A (blue glass) Size:900X900X2150mm 960X960X2150mm ) go d et r Sc ) ew M 6X (N y) 20 ut ) ) 7、Fix the nail (S e cr wM 6 6 X1 INSTALLATION GUIDE ) ( (G (S id as la eg k r Sc ew M 5X m 0m 15 ) et ss d go y) r (T ay (N ut ld Coater w t e Hoater pip wipe p ) ) p) ( Ex ed at or c De 09 ) 25 tr ca So cke pow soc ert of teleket supp phoof ly ne lin e 1
