STEAM BATHROOM MODEL : WS-905 、 WS-906 Your best choice!
Self-clean system TECHNIQUE PARAMETER Voltage Frequency AC110V(±10%) 60HZ Power of steam generator Water Volatge 0.1~0.2Mpa Power of water pump Power of heat pump Power of air pump Storage capacity Storage capacity 0.2KW （39gallon) （0.18m ) Step 2 Step 1 2.65KW 1.2HP 1.0KW 3 CAUTIONS: Heat pump and air bubble pump is required by customers.
CONSTRUCTION SKETCH Packing list Packing 1 14 two pieces of fixed glass door with aluminum,two pieces of sliding glass door with magnetic seal,four pieces of water resist strip,one piece of back board. 15 1 2 3 one piece of side door,one piece of side board. Packing 2 Packing 3 one tray,one roof, one piece of ordinary shower holding bar, one piece of black steam pipe with four pieces of black plastic pad, one set of foot massager. 38 20 Packing 4 28 one piece of post.
ATTENTION INSTALLATION SKETCH 150 ″) (5.9 The socket of power and the socket of telephone Cold water pipe 2150(84.6″) Hot water pipe 1800 (70.9″) 1400(55.1″) 550(21.6″) 1250 (49.2″) 35 0 (1 3 .8 20 ″) .9 0 (7 ″) Other screws 600(23.6″) 800(31.5″) M4x15 M4x25 Install the screw M6x25 Active chain wheel of glass 1000(39.4″) 1500(59″)/1350(53.1″) ILLUSTRATION OF INSTALLATION 1.
Attention: The machine must be fixed in the circuit which protected by creepage protectionand should be well-connected with the ground. Nontechnical people can not be fixed or removed at random. INSTALLATION PROCESS 1.Assembly of tray If the ground is not smooth,please adjust the nail under the tray to keep the balance of the tray and ground. 6、Technical parameter Model Voltage Current KL-824 110V Top light 20W Sidelight 5W 25A Fan 3.
4. Assembly of fixed glass door Put the left and right side fixed door into the up and down aluminum track to keep it balance,fixed them. STEP 4 wheel of glass door 5. Assembly of sliding door put the sliding door into the up and down aluminum track to keep it balance. (2) The application of the back lamp Press ,the sidelight is on. Press again, the ceiling lamp is out, press a third press, the sidelight is out too.
STEP 6 St4x20 1 4 2 5 3 6 6. Install the glass door onto the tray Put the plastic pad onto the aluminum post of glass door,if the length of the plastic is not suitable for the aluminum post,you can cut it in suitable size,then put it on the tray,screw with bolts.
DRAWING OF ELECTRICITY CONNECTION DRAWING OF WATER CONNECTION Instructions: 1.You should install the water heater yourself. 2.
