Replacement Part List

03887600 03/09 Page 2 of 2
3. Connect the license plate bracket light to the trailer
light wire harness (included in the trailer light kit p/n
71701300). See Figure 3.
NOTE: Secure loose wires when towing unit or when unit
is not in use to avoid damage to harness and connectors.
IMPORTANT: NEVER secure wires to fuel lines, positive
(+) battery cables, moving parts, surfaces that become
hot during operation, sharp edges or pinch points.
4. Connect wire harness to tow vehicle.
NOTE: Tow vehicle must be equipped with a standard
four pin trailer light connector (not included) in order to
connect tail lights.
5. Test lights to make sure brake lights, directional
lights and license plate bracket light are functioning
properly before towing the unit.
NOTE: If the lights do not turn on, check all connections
and fuses. Repair or replace as needed.
IMPORTANT: Check local, state and federal laws before
towing unit. Any modifications required to meet these
laws are the responsibility of the purchaser.
Figure 3
IC0015
Bullet Connector
Trailer Light Kit Wire Harness
CAUTION: Avoid damage or injury! Use
maximum caution when towing log splitter:
• DO NOT exceed 45 mph (72.4 kph)
• Obey all applicable local, state, and
federal laws regarding towing.
• DO NOT carry passengers, cargo or logs
on the towed unit.
• Allow for extra length of the unit when
turning, parking, crossing intersections
and in all driving situations.
• Ensure that stabilizers are locked in the
transport position and that the beam is
locked before moving unit.
• Drive slowly and take extra caution over
rough terrain.