Use and Care Guide

EN - 11
3. Repeat steps 1 – 2 on left ROPS bracket.
Bagger Supports
See Figure 6.
1. Install hex bolt (Item 8) into the right
bagger support with a spin lock flange nut
(Item 10) in the center of the bracket.
2. Secure hex bolt with a flat steel washer
(Item 11), spacer (Item 9) and top lock
flange nut (Item 7).
3. Repeat steps 1 – 2 on left bagger
support.
4. Install left bagger arm (Item 4) onto
bagger post (Item 2) with two hex bolts
(Item 16) and two top-lock flange nuts
(Item 7). Do not tighten. Repeat on right
bagger arm (Item 3). See Figure 7.
5. Position bagger post ends onto bagger
mounts. See Figure 8.
6. Ensure bagger posts are securely
engaged in bagger mounts. Lift and rotate
bagger post until bagger arms lock onto
the bagger support bolts. Ensure both
sides are latched. See Figure 9.
Figure 5
8
11
9
10
7
Figure 6
8
10
11
9
7
Figure 7
3
7
4
16
2
Figure 8