Operating Guide

EN - 17
Install Mesh Bag Assemblies
1. Install mesh bag assemblies to hood
assembly frame. The smooth heat-
resistance surfaces of the mesh bags
must face the engine. Close the hood and
connect rubber latch. See Figure 32.
Install Weights
1. Install weight bracket (item 35) onto
frame using two 3/8" x 3/4” round head
square neck bolts (item 36) and two 3/8”
locking top flange nuts (item 32). See
Figure 33.
2. Insert six weight plates (item 37) into
weight bracket and secure with two
1/2" x 2 1/4” hex bolts (item 39) and two
1/2" locking top flange nuts (item 38). See
Figure 34.
Figure 31
33
34
41
Figure 32
Rubber Latch
Smooth heat-resistant
side must face engine.
CAUTION: Always install
weights on front of mower
before operating unit with
bagger attached. Always
remove weights from front of
mower when bagger is
removed from the unit.
36
35
32
Figure 33
Figure 34
37
38
39