Product Manual
Table Of Contents
- Welcome
- Safety
- Practices & Laws
- Emission Control System
- Required Operator Training
- Safety Alert Symbol
- Signal Words
- Safety Decals
- Safety Rules
- Assembly
- Required Tools
- Unpack Unit
- Assemble Steering Levers
- Secure Seat Cable
- Secure Operator Presence Cable
- Install Deck Lift Pedal
- Install Trailer Hitch
- Prepare Unit for Operation
- Controls and Features
- Ignition Key
- Choke Control Knob
- Throttle Control Lever
- Power-Take-Off (PTO) Knob
- Hour Meter
- Height-of-Cut Dial
- Deck Lift Pedal
- Seat Adjustment Lever
- Parking Brake Lever
- Safety Interlock System
- Steering Levers
- Transaxle Bypass Levers
- Anti-scalp Wheels
- Operation
- Emergency Stopping
- Before Operating Unit
- Start the Engine
- Operate Unit
- Stop the Engine
- Move Unit Manually
- Transport Unit
- Maintenance
- Maintenance Schedule
- Service Parts
- Hour / Maintenance Meter
- Check Safety Interlock System
- Check Parking Brake
- Check Engine Oil
- Check Tire Pressure
- Check Carbon Canister Filter
- Check Fasteners
- Lubricate Unit
- Maintenance Preparation
- Check Mower Blades
- Check Battery
- Check Mower Belts
- Hydraulic Fluid
- Adjustments
- Adjust Seat
- Adjust Steering Levers
- Adjust Unit to Track Straight
- Adjust Parking Brake Lever
- Remove and Install Mower Deck
- Adjust Mower Deck
- Storage
- Short-Term Storage
- Long-Term Storage
- Start-of-Season Preparation
- Accessories
- Troubleshooting
- Specifications
- Warr anty
EN - 12
2. Remove nut from bolt on battery tray.
Retain nut. See Figure 5.
3. Tilt seat up slightly so cable end reaches
bolt on battery tray.
4. Install cable end onto bolt on battery tray
and secure with nut removed in step 2.
SECURE OPERATOR PRESENCE
CABLE
See Figure 6.
1. Insert cable clip into top hole on battery
tray.
2. Tip seat to upright position.
INSTALL DECK LIFT PEDAL
See Figure 7.
1. Remove hardware securing deck lift
pedal to unit and remove pedal.
2. Rotate pedal as shown in Figure 7 and
secure to unit with hardware removed in
step 1.
INSTALL TRAILER HITCH
See Figure 8.
1. Remove trailer hitch, four 3/8-16 x 3/4"
round head square neck bolts and four
3/8"-16 flange nuts from plastic bag in the
shipping container.
2. Position trailer hitch over frame as shown
in Figure 8.
3. Align holes in frame with holes in trailer
hitch and secure with hardware from step
1.
PREPARE UNIT FOR OPERATION
1. Connect battery. See Install Battery on
page 22.
2. Adjust seat to a comfortable position. See
Adjust Seat on page 27.
Figure 5
Figure 6
Figure 7
1. Deck Lift Pedal
2. Deck Lift Arm
3. Round Head Square Neck Bolt
4. Center Locking Flange Nut
4
1
2
3
Figure 8