Product Manual
Table Of Contents
- Welcome
- Safety
- Practices & Laws
- Emission Control System
- Required Operator Training
- Safety Alert Symbol
- Signal Words
- Safety Decals
- Safety Rules
- Controls and Features
- Ignition Key
- Choke Control Knob
- Throttle Control Lever
- Power-Take-Off (PTO) Knob
- Hour Meter
- Height-of-Cut Dial
- Deck Lift Pedal
- Seat Adjustment Lever
- Parking Brake Lever
- Safety Interlock System
- Steering Levers
- Transaxle Bypass Levers
- Anti-scalp Rollers
- Operation
- Emergency Stopping
- Before Operating Unit
- Start the Engine
- Operate Unit
- Stop the Engine
- Move Unit Manually
- Transport Unit
- Maintenance
- Maintenance Schedule
- Service Parts
- Service Position
- Check Safety Interlock System
- Check Parking Brake
- Check Engine Oil
- Check Tire Pressure
- Check Carbon Canister Filter
- Check Fasteners
- Lubricate Unit
- Check Mower Blades
- Check Battery
- Check Mower Belts
- Hydraulic Oil
- Adjustments
- Adjust Seat
- Adjust Steering Levers
- Adjust Unit to Track Straight
- Adjust Parking Brake Lever
- Remove and Install Mower Deck
- Adjust Mower Deck
- Troubleshooting
- Storage
- Short-Term Storage
- Long-Term Storage
- Start-of-Season Preparation
- Accessories
- Specifications
- Warr anty
- Blank Page
EN - 22
See Figure 19.
2. Place battery on battery tray so terminals
are positioned nearest right side of unit.
3. Install battery bracket over battery and
onto bolts in battery tray.
4. Reinstall L-bracket onto bolt and secure
with flange nut.
5. Secure remaining battery bracket end to
battery tray with original flange nut.
6. Connect positive cable to positive battery
terminal and then the negative cable to
negative battery terminal.
7. Return seat to operating position.
Install U1 Battery
1. Remove factory battery. See Remove
Battery on page 21.
2. Remove hardware from L-bracket and
secure L-bracket to battery bracket. See
Figure 20.
3. Place U1 battery in battery tray so
terminals are positioned toward the front
of unit.
4. Install battery bracket over battery and
onto bolts in battery tray. Secure with two
flange nuts. See Figure 21.
5. Connect positive cable to positive battery
terminal and then the negative cable to
negative battery terminal.
6. Return seat to operating position.
Clean Battery
1. Remove battery from unit. See Remove
Battery on page 21.
2. Clean terminals and battery cable ends
with a wire brush.
3. Coat terminals with dielectric grease or
petroleum jelly.
Figure 18
Figure 19
1. Negative Battery Terminal
2. L-Bracket
1
2
Figure 20
Figure 21
1. Positive Battery Terminal
2. Negative Battery Terminal
1
2