Product Manual

EN - 27
Purge Hydraulic System
1. With the unit up to and facing a wall, jack
up the unit so that both drive wheels are
off the ground.
2. Disengage the parking brake and put the
transaxle bypass levers in the neutral
position (see Move Unit Manually on
page 15).
3. Start the engine and slowly move the
steering levers in forward and reverse five
or six times.
4. Stop the engine and put the transaxle
bypass levers in the drive position (see
Move Unit Manually on page 15).
5. Start the engine and slowly move the
steering levers in forward and reverse five
or six times.
6. Stop the engine, check the oil level and
add oil as needed.
7. Repeat steps 2 – 6 until the transaxles
operate smoothly in forward and reverse
at normal speeds without excessive
noise.
ADJUST SEAT
See Figure 31.
1. Pull seat adjustment lever up to unlock
seat.
2. Move seat to desired position.
3. Release seat adjustment lever to lock
seat in place.
ADJUST STEERING LEVERS
Adjust Steering Lever Height
See Figure 32.
1. Remove hardware securing steering
lever to upper control arm.
2. Place steering lever in desired adjusting
hole.
• Use upper and middle holes for highest
lever position.
• Use middle and lower holes for lowest
lever position.
3. Reinstall hardware in upper control arm.
4. Align levers side to side. See Adjust
Steering Lever Reach on page 28.
5. Fully tighten hardware.
WARNING: This adjustment
requires operating the engine.
Use extreme care to avoid
contact with moving parts and
hot surfaces. Be sure rear of
unit is well supported and
secure before starting engine.
ADJUSTMENTS
WARNING: AVOID INJURY.
Read and understand the
Safety section before
proceeding.
Figure 31