Product Manual
Table Of Contents
- Welcome
- Safety
- Practices & Laws
- Emission Control System
- Required Operator Training
- Safety Alert Symbol
- Signal Words
- Safety Decals
- Safety Rules
- Controls and Features
- Ignition Key
- Choke Control Knob
- Throttle Control Lever
- Power-Take-Off (PTO) Knob
- Hour Meter
- Height-of-Cut Dial
- Deck Lift Pedal
- Seat Adjustment Lever
- Parking Brake Lever
- Safety Interlock System
- Steering Levers
- Transaxle Bypass Levers
- Anti-scalp Rollers
- Operation
- Emergency Stopping
- Before Operating Unit
- Start the Engine
- Operate Unit
- Stop the Engine
- Move Unit Manually
- Transport Unit
- Maintenance
- Maintenance Schedule
- Service Parts
- Service Position
- Check Safety Interlock System
- Check Parking Brake
- Check Engine Oil
- Check Tire Pressure
- Check Carbon Canister Filter
- Check Fasteners
- Lubricate Unit
- Check Mower Blades
- Check Battery
- Check Mower Belts
- Hydraulic Oil
- Adjustments
- Adjust Seat
- Adjust Steering Levers
- Adjust Unit to Track Straight
- Adjust Parking Brake Lever
- Remove and Install Mower Deck
- Adjust Mower Deck
- Troubleshooting
- Storage
- Short-Term Storage
- Long-Term Storage
- Start-of-Season Preparation
- Accessories
- Specifications
- Warr anty
- Blank Page
EN - 32
Set Blade Pitch
Pitch is the difference in blade height from
front to back.
IMPORTANT: Level the mower deck before
setting blade pitch.
1. Set deck to highest cutting height.
2. Position mower blades so blade ends
point front to back.
3. On both sides of the unit, measure the
distance to the ground at the front and
rear tip of the blade. See Figure 44.
• If the front tip of the blade is ± 0.635 cm
(1/4") lower than the rear, no
adjustment is needed.
• If adjustments are needed, adjust the
nylon locking flange nut on the deck
link. Tighten the nut to raise the deck;
loosen the nut to lower the deck. See
Figure 43.
Figure 44