Operating Guide

EN - 25
4. Reinstall belt covers and secure with
original hardware.
IMPORTANT: Make sure belt has tension and
remains aligned after installation is complete.
Remove Ground Drive Belt
IMPORTANT: Retain all parts for
reinstallation.
1. Place unit in service position. See
Service Position on page 18.
2. Remove deck drive belt. See Remove
Deck Drive Belt on page 23.
3. Position deck at lowest cutting height.
4. Loosen nut on eye bolt and disconnect
idler arm spring. See Figure 32.
See Figure 33.
5. Remove the right-side self-tapping screw
from heat shield and rotate shield out of
the way.
6. Remove two self-tapping screws from
clutch stop bracket and remove bracket.
Figure 30
52" Decks
Figure 31
60" Decks
Figure 32
1. Nut
2. Eye Bolt
3. Idler Arm Spring
1
2
3
6.1 cm
(2.4")
Figure 33
1. Heat Shield
2. Clutch Stop Bracket
3. Self-tapping Screw
1
2
3