Operating Guide

EN - 29
See Figure 40.
6. Loosen nut on hex bolt supporting
eccentric spacer.
7. Rotate eccentric spacer around hex bolt
until levers are at the same height.
8. Tighten nut.
Adjust Steering Lever Reach
See Figure 41.
1. Loosen hardware securing steering lever
to upper control arm.
2. Pivot steering lever to desired position.
3. Ensure levers are aligned with each
other.
4. Tighten hardware.
ADJUST UNIT TO TRACK
STRAIGHT
NOTICE: Reverse travel can only be
adjusted by your Ariens dealer.
Check Tire Pressure
1. Check pressure of both tires. See
Specifications on page 37 for
recommended tire pressure.
2. Recheck unit tracking. If unit still does not
track straight, note which side the unit
pulls toward and increase the tire
pressure on that side.
IMPORTANT: DO NOT exceed maximum tire
pressure listed on tire sidewall.
If increasing tire pressure on one side does
not correct tracking problem, adjust the
steering levers.
Adjust Steering Levers
See Figure 42.
If adjusting tire pressure did not correct
tracking problem:
1. Loosen jam nut on adjustment bolt of
steering lever that needs adjustment.
2. Adjust drive wheel speed.
Turn adjustment bolt counterclockwise
to increase steering lever travel and
drive wheel speed.
Turn adjustment bolt clockwise to
decrease steering lever travel and drive
wheel speed.
3. Tighten jam nut.
Figure 39
1. Adjusting Hole
2. Mounting Hole
3. Steering Lever
4. Upper Control Arm
3
4
2
1
Figure 40
3
1
2
1. Eccentric Spacer
2. Hex Bolt
3. Nut
Figure 41
1. Steering Lever
2. Upper Control Arm
3. Hardware
1
3
2