Use and Care Manual

EN - 8
NOTICE: See Figure 12 for part descriptions
and locations.
1. Remove unit from crate.
2. Support draw bar. Remove and dispose
of four 1/4 x 1/2" Taptite bolts retaining
draw bar to frame.
3. Fold front stand down and lock in place
with clevis pin and hairpin clip. See
Figure 4.
4. Position draw bar in frame and attach
using two 1/2 x 3" hex bolts and two 1/2"
hex nuts. See
Figure 5.
5. Ensure that beam assembly lock is
seated in hole and rotate beam into
horizontal position until it locks into
position. Lock must engage fully. See
Figure 6.
6. Remove three hex bolts retaining
stripper plates and remove stripper
plates. Retain hardware and stripper
plates.
7. Remove 1/2" hex bolt, two 9/16"
washers, and 1/2" flange nut to remove
splitter wedge. Retain hardware. See
Figure 7.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section in the Owner’s Manual
before proceeding.
DO NOT start engine until instructed
and all assembly steps have been
completed.
Figure 4
Figure 5
Figure 6
Figure 7