Use and Care Manual

EN - 12
CONTROLS AND FEATURES
See Figure 12 for all controls and features
locations.
Engine Switch (Item 2)
The engine switch has
two positions:
1. OFF
Engine will not start or
run.
2. ON
Engine will start and run.
Choke Control Lever (Item 3)
1. START
(Choke Closed):
Chokes off air to
engine for easier
starting.
2. RUN
(Choke Open):
Allows for normal
operation.
IMPORTANT: Gradually open choke after
engine starts.
Fuel Shut-Off Valve (Item 4)
IMPORTANT: The fuel shut-off valve MUST
be in the closed position before transporting
the unit.
The fuel shut-off
valve has two
positions:
1. OFF
Use this position
to service,
transport, or store
the unit.
2. ON
Use this position
to run the unit.
Recoil Starter Handle (Item 20)
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back
against starter.
Control Lever (Item 9)
(Figure 13)
The control lever is used to move the splitting
wedge in or out when operating in the
horizontal position or up and down when
operating in the vertical position.
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before proceeding.
1
2
2
1
1
2
Figure 13
Horizontal Splitting
Vertical Splitting
Return
Extend
Neutral
Up
Down
Neutral
9
18