Use and Care Manual

EN - 14
To remove stuck logs from the splitter wedge:
1. Move the control lever to the Return/Up
position.
2. Allow the cylinder to retract until the
stuck log contacts the stripper plates.
3. Continue to retract the cylinder until the
log is dislodged from the splitter wedge.
4. Once removed from the splitter wedge
rotate log and split from a different
location or split log from the other end.
Front Stand (Item 6)
(Figure 17)
Front stand must be locked in the down
position whenever the unit is in use and in the
transport position when moving or towing the
unit.
1. Remove hair pin from clevis pin and
remove clevis pin from tongue bracket.
2. Rotate stand up or down until the top
edge of the handle on the stand aligns
with the transport-position hole in the
tongue bracket.
3. Insert clevis pin into tongue bracket and
insert hair pin.
Rear Stabilizer (Item 12)
(Figure 18)
Rear stabilizer must be positioned down and
locked in place when operating in the
horizontal position.
1. Remove hair pin from upper lock pin and
slide lock pin out from brackets.
2. Rotate rear stabilizer down until holes in
stabilizer align with holes in brackets.
3. Insert lock pin all the way through
brackets and stabilizer.
4. Reinstall hair pin.
IMPORTANT: Rear stabilizer must be locked
in the transport position before towing unit or
before placing beam in vertical operating
position.
CAUTION: Do not use the unit if
the stripper plates are bent or
damaged. Bent or damaged
stripper plates must be repaired
or replaced before use.
CAUTION: Front stand must be
locked in the transport position
before towing the unit.
Figure 17
Remove hair
pin and clevis
pin and rotate
stand up or
down.
Reinstall clevis
pin and hair pin.