Use and Care Guide

EN - 10
Install Remote Deflector Cable
Models 920021, 022
(Figures 7 and 8)
1. Pull rubber seal cap away from snap
fitting (Figure 7).
.
2. Install snap fitting into cable bracket’s
mounting hole located under the control
panel.
3. Position rubber seal cap over the top of
snap fitting.
4. Move deflector control lever to rear most
position.
5. Attach cable eye to pin on bottom of
deflector control lever.
NOTICE: Hold down chute deflector cap, if
needed, for more cable slack.
6. Secure cable eye to control lever with
bushing and hairpin.
7. Using the wire hook attached to the
deflector cable, hook cable to discharge
chute crank.
8. Install cable into clip on top of discharge
chute pedestal (Figure 8).
.
9. Make sure deflector cable loops above
gear cover between cable clip and cable
support bracket (Figure 8).
10. Test controls to be sure deflector works
properly.
NOTICE: If deflector does not follow full
range of travel see Remote Discharge
Deflector Control Adjustment on page 27.
Check Function of Dual Handle
Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction drive
clutch lever is released, then both clutches
must disengage. If they do not, contact your
Dealer for repairs.
Figure 7
1. Mounting Hole
2. Snap Fitting
3. Rubber Seal Cap
4. Hairpin
5. Bushing
6. Cable Eye
2
1
3
4
6
5
Figure 8
1. Remote Deflector Cable
2. Remote Deflector Control
3. Cable Clip
4. Wire Cable Hook
5. Cable Mounting Bracket
6. Cable Support Bracket
7. Gear Cover
1
3
2
4
5
7
6