Use and Care Guide

EN - 11
Check Tire Pressure
Models 920013, 021
Check tire pressure and adjust to the
pressure listed on tire sidewall.
Check Track Tension
Model 920022
Check tracking of unit and tension the tracks
as required (see Track Tension Adjustment
on page 35).
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Check
Auger Gearcase on page 22).
Check Engine Crankcase Oil
IMPORTANT: The engine may be shipped
with oil in crankcase. Refer to Engine Manual
for detailed instructions.
Fill Engine Fuel Tank
Fill fuel tank. DO NOT OVERFILL! See
FILLING FUEL TANK on page 18.
Check Function Of All Controls
Ensure unit runs and performs properly. Refer
to OPERATION on page 15.
Run-in Attachment Belt
1. Start unit in a well-ventilated area
according to Starting and Shut Off on
page 19.
2. Engage attachment clutch lever and run
attachment for about 15 minutes.
3. Stop unit, wait for all moving parts to
stop, and remove spark plug wire.
4. Adjust clutch idler according to
Attachment Clutch/Brake Adjustment on
page 28.
5. Adjust belt finger, if necessary. See
Check Belt Finger Clearance on
page 30.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment and
experience to perform the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and
tire assembly. Heat can cause an
increase in air pressure resulting in
an explosion. Welding can
structurally weaken or deform the
wheel.
• Do not stand in front or over the tire
assembly when inflating. Use a clip-
on chuck and extension hose long
enough to allow you to stand to one
side.