Use and Care Guide

EN - 24
GENERAL LUBRICATION
(Figures 18 and 19)
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
NOTICE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 37.
Sno-Thro should be lubricated at beginning of
season or every 25 operating hours.
Auger Shaft
NOTICE: To grease auger shaft, remove
shear bolt nuts and shear bolts. Apply grease
at the grease zerks and then turn the auger
assemblies on the auger shaft. Replace
shear bolts per instructions in Shear Bolts on
page 26.
Figure 18
Grease
Oil
2x
Models 920013, 021