Use and Care Guide

EN - 27
MANUAL DISCHARGE CHUTE
DEFLECTOR
Model 920013
(Figure 22)
Deflector must stay in selected position while
throwing snow.
To adjust, loosen then retighten the wing
knob to desired tension.
REMOTE DISCHARGE
DEFLECTOR CONTROL
ADJUSTMENT
Models 920021, 022
(Figures 23 and 24)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control
(Figure 23).
.
If deflector does not follow full range of travel:
1. Push deflector remote all the way to rear
most position.
2. Loosen adjusting nuts on remote
deflector cable attached to the chute
deflector (Figure 24).
3. To adjust the deflector lower:
Loosen bottom adjustment nut and
tighten top adjustment nut.
To adjust deflector higher:
Loosen top adjustment nut and tighten
bottom adjustment nut.
4. Check the deflectors range of travel and
repeat adjustment as necessary.
Figure 22
1. Wing Knob
2. Discharge Chute Deflector
3. Discharge Chute
1
2
3
Figure 23
Adjustment Nut
Figure 24
2
1
1. Adjusting Nuts
2. Cable Support Bracket
3. Remote Deflector Control Cable
3