Use and Care Manual

EN – 10
See Figure 10.
15. Remove attachment drive belts from attachment
sheave.
To assist belt removal, slowly pull recoil starter handle
while gently guiding belts out of attachment sheave.
See Figure 11.
16. Position support, such as a trash can, under
handlebars so tractor / frame remains upright when
separated from auger housing.
17. Chock or block wheels to prevent tractor / frame
movement.
See Figure 12.
18. Remove hardware securing auger housing to frame.
19. Lift auger housing rear slightly to disengage from
mount rod and separate from unit.
Reinstall Auger Housing
See Figure 13.
1. With assistance from an adult helper, engage
attachment clutch lever so attachment brake will not
obstruct attachment drive pulley in step 2.
2. Tilt auger housing rear up and lower mount brackets
onto mount rod.
WARNING: AVOID INJURY. Attachment sheave
edges are sharp. Wear thick gloves to remove
belts from attachment sheave.
Figure 10
Figure 11
Figure 12
Figure 13