Use and Care Manual

EN – 48
See Figure 114.
4. Remove hardware retaining gearcase cover and
remove cover.
5. Remove gasket and drain gearcase.
6. Remove bushing retainer from gearcase. See
Figure 115.
See Figure 116.
7. Press auger shaft through the right side of gearcase.
NOTICE: DO NOT strike auger shaft end; use a press.
8. Remove seal, bushing and washer from auger shaft.
9. With a flathead screwdriver or similar pry bar, remove
front seal cover and discard. See Figure 117.
Figure 114
Figure 115
Figure 116
Figure 117