Use and Care Guide

EN - 14
Your Ariens dealer can provide service and
adjustments to keep your unit operating at
peak efficiency. Contact an authorized engine
manufacturer’s service center for engine
service.
SERVICE POSITION
IMPORTANT: DO NOT tip unit onto brush.
Remove brush attachment if maintenance
requires tipping unit forward. Ensure unit is
secure and will not tip.
Place Unit in Service Position
1. Move unit to a flat, level surface.
2. Stop engine and wait for moving parts to
stop and for hot parts to cool.
3. Loosen, but DO NOT remove hardware
securing belt cover and remove belt
cover.
See Figure 17.
4. Remove hardware securing belt finger
and remove belt finger.
5. Remove attachment drive belt from
attachment sheave.
6. Disconnect brush lock cable from J-clamp
on engine mount.
See Figure 18.
7. Remove hardware securing brush lock
trigger to handlebar and allow trigger to
rest on brush attachment.
See Figure 19.
MAINTENANCE
WARNING: Read and
understand the
Safety section
before proceeding.
WARNING: AVOID INJURY.
Before rotating unit, close fuel
valve and drain fuel from tank
and fuel system. (Refer to
engine manual for insturctions.)
Make sure unit is secure and will
not tip.
Figure 17
1
2
4
3
6
5
1. Belt Finger
2. Hex Bolt
3. Locking Washer
4. Flat Steel Washer
5. Attachment Drive Belt
6. Attachment Sheave
Figure 18
1. J-Clamp
2. Brush Lock Cable
1
2