Use and Care Guide

EN - 18
IMPORTANT: If cover is clogged with snow,
remove it and allow foam to thaw or rinse with
warm water. Allow cover to dry before
reinstalling.
IMPORTANT: More frequent service may be
required in extreme conditions (heavy loads,
high ambient temperatures, dusty conditions
or airborne debris).
LUBRICATE UNIT
Ariens recommends using Ariens Hi-Temp
Grease or equivalent (
see Service Parts on
page 17) to lubricate fittings. Lubricate each
season or every 25 hours of operation.
IMPORTANT: Wipe each fitting clean before
and after lubrication.
Use the following key for all lubrication
procedures.
Drive Chains
1. Remove hardware retaining left brush
cover and remove cover.
See Figure 23.
2. Lubricate entire chain lengths.
3. Reinstall brush cover and secure with
four tapping screws and four hex bolts.
Casters
See Figure 24.
Traction Drive
1. Place unit in service position. See
Service Position on page 14.
2. Lubricate as shown in Figure 25 and
Figure 26.
IMPORTANT: DO NOT allow grease or oil to
contact friction disc, swing gate or belts.
* = Lubricate on Both Sides
Grease
Oil
Figure 23
Figure 24
*
*
Figure 25