Use and Care Guide

EN - 19
3. Return unit to operating position. See
Return Unit to Operating Position on
page 16.
ADJUST SPEED SELECTOR
LEVER
See Figure 27.
1. Stop engine and wait for moving parts to
stop and for hot parts to cool.
2. Disconnect adjustment pivot pin from
speed selector arm. Save hardware for
reinstallation.
3. Position speed selector lever in fastest
forward position.
4. Turn speed selector arm down as far as it
will go.
5. Thread adjustment pivot pin along shift
rod until it aligns with the mating hole on
the speed selector arm, and then insert
the pivot pin in the hole.
6. Connect pivot pin to speed selector arm
with hardware removed in step
2 and
check forward and reverse speeds.
a. Start unit, position speed selector
lever in the first forward position and
engage traction drive clutch. Unit
should move forward.
b. Stop unit, position speed selector
lever in the first reverse position and
engage traction drive clutch. Unit
should move in reverse.
c. Stop unit. If unit does not travel
correctly, repeat adjustments.
ADJUST ATTACHMENT CLUTCH
& BRAKE
Remove Slack from Attachment
Cable
1. Stop engine and wait for moving parts to
stop and for hot parts to cool.
2. Disconnect spark plug wire.
3. Loosen hardware securing belt cover to
unit and remove belt cover.
ADJUSTMENTS
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before
proceeding.
Figure 26
*
*
WARNING: AVOID INJURY.
Improper adjustment could
result in unexpected movement
of brush causing death or
serious injury. BRUSH MUST
STOP within 5 seconds when
attachment clutch lever is
released.
1. Speed Selector Arm
2. Hairpin
3. Adjustment Pivot Pin
4. Shift Rod
Figure 27
1
2
4
3