Use and Care Guide

EN - 20
IMPORTANT: DO NOT completely remove
hardware from unit.
4. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel down to shorten cable and remove
cable slack.
See Figure 28.
5. With the attachment clutch disengaged,
check that the attachment idler arm lightly
touches the frame.
See Figure 29.
6. Tighten jam nut on cable adjustment
barrel.
See Figure 28.
7. Reinstall belt cover and tighten hardware.
8. Reconnect spark plug wire.
Check Attachment Idler Arm Roller
Clearance
See Figure 30.
1. Place unit in service position and remove
bottom cover.
See Service Position on
page 14.
2. Engage attachment clutch and check the
clearance between the frame and plastic
roller on attachment idler arm. Roller
should be 12.7 mm – 22.2 mm (1/2" –
7/8") from frame.
• If roller is 12.7 mm – 22 mm (1/2" –
7/8") from frame, no further adjustment
is required.
• If roller is less than 12.7 mm (1/2") from
frame, loosen idler adjustment nut and
move idler closer to belt. Tighten
adjustment nut and recheck roller
clearance.
• If roller is more than 22.2 mm (7/8")
from frame, loosen idler adjustment nut
and move idler away from belt. Tighten
adjustment nut and recheck roller
clearance.
3. Return unit to operating position. See
Return Unit to Operating Position on
page 16.
Figure 28
1. Attachment Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
1
2
3
Figure 29
1. Attachment Idler Arm
2. Frame
1
2
Figure 30
1. Plastic Roller
2. Frame
3. Attachment Idler Arm
1
2
3