Use and Care Guide

EN - 6
Disengage attachment when not in use and
when traveling from one work area to
another.
Disengage power to the attachment when
unit is transported or not in use.
Use only attachments and accessories
approved by the manufacturer of the unit
(such as wheel weights, counterweights or
cabs).
This product is equipped with an internal
combustion engine. DO NOT use unit on or
near any unimproved, forest-covered or
brush-covered land unless exhaust system
is equipped with a spark arrester meeting
applicable local, state or federal laws. A
spark arrester, if used, must be maintained
in effective working order by operator.
NEVER operate the unit without good
visibility or light. ALWAYS be sure of your
footing, and keep a firm hold on the handles.
Walk; NEVER run.
NEVER operate unit after or during the use
of medication, drugs or alcohol. Safe
operation requires complete and unimpaired
attention at all times.
NEVER allow anyone to operate this unit
when their alertness or coordination is
impaired.
NEVER touch a hot engine or muffler.
Avoid contact with sharp edges; sharp
edges can cut.
Maintenance and Storage
Secure unit so it will not tip over during
maintenance.
Before cleaning, removing obstructions or
making any inspections, repairs, etc.,
disengage clutch(es), stop engine, remove
key, allow moving parts to stop and hot parts
to cool.
Check hardware at frequent intervals for
proper tightness to be sure the unit is in safe
working condition.
Check clutch and brake operation
frequently.
DO NOT change engine governor settings
and DO NOT over-speed engine.
Adjust and service as required. Motion of
drive wheels and attachment must stop
quickly when clutch levers are released.
ALWAYS maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
Keep unit free of ice or other debris. Clean
up oil or fuel spills.
ALWAYS keep protective structures, guards,
and panels in good repair and secured in
place. NEVER modify or remove safety
devices.
NEVER store the unit with fuel in the fuel
tank inside a building where ignition sources
are present such as hot water heaters,
space heaters or clothes dryers. Close fuel
valve and allow the engine to cool
completely before storing in any enclosure
or covering the unit.
ALWAYS refer to operator's manual for
important details if the unit is to be stored for
an extended period.
Maintain or replace safety and instruction
labels as necessary.
Run the unit a few minutes after removing
snow to prevent freeze-up.
Personal Protection
DO NOT operate the equipment without
wearing adequate clothing. Avoid loose
fitting clothing that can get caught in moving
parts. Wear footwear that will improve
footing on slippery surfaces.
Wear adequate safety gear, including safety
glasses with side shields and protective
gloves.
DO NOT wear loose clothing or jewelry, and
tie back hair that may get caught in rotating
parts.
NEVER attempt to clear obstructions or
clean unit while engine is running. Rotating
attachments can cause serious injury.
Protect eyes, face and head from objects
that may be thrown from unit. Wear
appropriate hearing protection.
ALWAYS wear safety glasses or eye shields
during operation or while performing an
adjustment or repair to protect eyes from
foreign objects that may be thrown from the
unit.
Slope Operation
Exercise extreme caution when operating on
slopes. DO NOT operate on steep slopes.
DO NOT operate across the face of slopes;
go up and down. Keep all movement on
slopes slow and gradual.