Use and Care Manual

EN - 18
3. Reinstall brush cover and secure with
four tapping screws and four hex bolts.
Casters
See Figure 23.
Traction Drive
1. Place unit in service position. See
Service Position on page 13.
2. Lubricate as shown in Figure 24 and
Figure 25.
IMPORTANT: DO NOT allow grease or oil to
contact friction disc, swing gate or belts.
3. Return unit to operating position. See
Return Unit to Operating Position on
page 15.
ADJUST SPEED SELECTOR
LEVER
See Figure 26.
1. Stop engine and wait for moving parts to
stop and for hot parts to cool.
2. Disconnect adjustment pivot pin from
speed selector arm. Save hardware for
reinstallation.
3. Position speed selector lever in fastest
forward position.
4. Turn speed selector arm down as far as it
will go.
5. Thread adjustment pivot pin along shift
rod until it aligns with the mating hole on
the speed selector arm, and then insert
the pivot pin in the hole.
Figure 23
*
*
Figure 24
ADJUSTMENTS
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before
proceeding.
Figure 25
*
*