Use and Care Manual

EN - 19
6. Connect pivot pin to speed selector arm
with hardware removed in step 2 and
check forward and reverse speeds.
a. Start unit, position speed selector
lever in the first forward position and
engage traction drive clutch. Unit
should move forward.
b. Stop unit, position speed selector
lever in the first reverse position and
engage traction drive clutch. Unit
should move in reverse.
c. Stop unit. If unit does not travel
correctly, repeat adjustments.
ADJUST ATTACHMENT CLUTCH
& BRAKE
Remove Slack from Attachment
Cable
1. Stop engine and wait for moving parts to
stop and for hot parts to cool.
2. Disconnect spark plug wire.
3. Loosen hardware securing belt cover to
unit and remove belt cover.
IMPORTANT: DO NOT completely remove
hardware from unit.
4. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel down to shorten cable and remove
cable slack. See Figure 27.
5. With the attachment clutch disengaged,
check that the attachment idler arm lightly
touches the frame. See Figure 28.
6. Tighten jam nut on cable adjustment
barrel. See Figure 27.
7. Reinstall belt cover and tighten hardware.
8. Reconnect spark plug wire.
WARNING: AVOID INJURY.
Improper adjustment could
result in unexpected movement
of brush causing death or
serious injury. BRUSH MUST
STOP within 5 seconds when
attachment clutch lever is
released.
Figure 26
1. Speed Selector Arm
2. Hairpin
3. Adjustment Pivot Pin
4. Shift Rod
1
2
4
3
Figure 27
1. Attachment Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
1
2
3
Figure 28
1. Attachment Idler Arm
2. Frame
1
2