Specifications

EN - 18
IMPORTANT: DO NOT force frozen chute
controls. If frozen, take to warm place until
controls are free.
Heated Handles
Turn the heated handles
switch to the ON (1)
position to activate. Turn
the switch to the OFF (2)
position to deactivate.
Scraper Blade
The scraper blade allows better contact with
the surface being cleared. It also prevents
damage to the housing from normal usage.
IMPORTANT: DO NOT allow Scraper Blade
to wear too far or Auger/Impeller housing will
become damaged.
Skid Shoes
The skid shoes control the distance between
the scraper blade and the ground. Adjust skid
shoes equally to keep blade level with the
ground. Refer to Pre-Start on page 20 for
recommended settings.
Drift Cutters
(Figure 13)
Drift cutters break up snow drifts that are
taller than the auger housing and direct the
snow into the auger. Store the drift cutters on
the auger housing when not in use. Install
them as shown below so they are taller than
the snow to be cleared.
Track Angle
(926324)
(Figure 14)
The track angle can be adjusted to position
the auger housing for level clearing, deep
cutting or transport.
Squeeze the handlebar trigger and press
down on the handlebars to move the auger
housing into an up position. Release the
trigger to hold the position.
Squeeze the handlebar trigger and lift up on
the handlebars to move the auger housing
into the down position. Release the trigger to
hold the position.
Figure 12
1
2
Figure 13
Stored Position
Operating Position