Product Manual
Table Of Contents
- Welcome
- Safety
- Practices & Laws
- Emission Control System
- Required Operator Training
- Safety Alert Symbol
- Signal Words
- Safety Decals
- Safety Rules
- Assembly
- Controls and Features
- Ignition Key
- Throttle Control Lever
- Power-Take-Off (PTO) Knob
- Hour Meter
- Height-of-Cut Adjustment System
- Transport Lock Release Lever
- Deck Lift Pedal
- Seat Adjustment Lever
- Parking Brake Lever
- Safety Interlock System
- Steering Levers
- Transaxle Bypass Levers
- Anti-scalp Rollers
- Operation
- Emergency Stopping
- Before Operating Unit
- Start the Engine
- Operate Unit
- Stop the Engine
- Move Unit Manually
- Transport Unit
- Release transport lock
- Maintenance
- Service Position
- Maintenance Schedule
- Service Parts
- Hour / Maintenance Meter
- Check Safety Interlock System
- Check Parking Brake
- Check Engine Oil
- Check Tire Pressure
- Check Carbon Canister Filter
- Check Fasteners
- Lubricate Unit
- Check Mower Blades
- Battery Service
- Check Mower Belts
- Check Hydraulic System
- Service & Adjustments
- Adjust Seat
- Adjust Unit to Drive Straight
- Adjust Transaxles
- Electrical Service
- Replace Transaxle Drive Belt
- Adjust Anti-Scalp Rollers
- Adjust Parking Brake Lever
- Remove and Install Mower Deck
- Level and Pitch Mower Deck
- Troubleshooting
- Storage
- Short-Term Storage
- Long-Term Storage
- Start-of-Season Preparation
- Accessories
- Specifications
- Specifications
- Warr anty
EN - 32
5. Remove transaxle drive belt from drive
system in the following order:
a. From right transaxle sheave.
b. From left transaxle sheave.
c. From clutch sheave.
Install Transaxle Drive Belt
See Figure 41.
1. Install transaxle drive belt to drive system
in the following order:
a. Around clutch sheave.
b. Around left transaxle sheave.
c. Around right transaxle sheave.
2. Align belt with idler pulley.
3. Reinstall idler spring hook onto anchor
bolt. Make sure belt has tension and is
aligned in all pulleys.
4. Reinstall clutch stop bracket and secure
with original hardware. See Figure 42.
5. Reinstall PTO belt. See Install PTO Belt
on page 30.
Reverse Clutch Brake Plates
See Figure 43.
1. Remove hardware securing brake plates
to clutch bracket. Retain for reinstallation.
2. Reverse the brake plates and secure to
clutch bracket using original hardware.
Figure 41
1. Spring
2. Idler Pulley
1
2
Figure 42
Figure 43