Specifications

GB - 10
Cutting Angle Adjuster
Controls the cutting angle of the blade for
decorative edging.
1. Push the lever forward to unlock the
head and then rotate it left or right to set
the desired edging angle.
NOTE: The head pivots from about
70 degrees to 180 degrees.
IMPORTANT: Make sure the front wheel
does not contact the blade when angling the
blade for a beveled edge.
Rear Wheel Height Adjuster
Sets the rear wheel height to support the
edger when working along curbs or other
uneven terrain.
1. Loosen the knob and position the wheel
so it supports the unit level when
operating, and then securely tighten the
knob.
NOTE: Set the wheel height before starting
the engine or engaging the blades.
Rotate the head to the desired angle.
Make sure the lever locks into place.
Push the lever forward slightly
to unlock the head.
Figure 6
The head pivots from about
70 degrees to 180 degrees.
Loosen knob, position
wheel at the desired height
and replace the knob.
Figure 7