Specifications

GB - 11
Front Wheel Adjuster
Positions the front wheel on the axle to
balance the unit when working along curbs or
other uneven terrain.
NOTE: Make sure the front wheel rolls on the
work surface.
IMPORTANT: Make sure the cutting blade
will not contact wheel before starting the
engine.
1. With the engine shut off, remove the pin
from the axle and position the front
wheel on the right or left side of the axle
as needed, and secure in position with
the hair pin.
Position the wheel away from the blade
when bevel cutting or trimming.
Position the wheel nearer the blade for
edging.
Engine Controls
Throttle
Throttle controls engine speed.
1. Set the throttle to slow (turtle) to start the
unit and when traveling between work
areas.
2. Set the throttle to fast (rabbit) when
edging.
Choke
Controls the air-fuel mixture in the carburetor.
1.Close the choke when starting a
cold engine.
2.Once the engine starts and begins
to warm, open the choke for
operation.
NOTE: Do not choke a warm engine.
Fuel Shut Off
1. Push the lever down to close the fuel
shut off valve for transporting, servicing
or storing the unit.
2. Pull the lever up to open the fuel shut off
valve for operating the unit.
Engine Shut Off Switch
1. Set the engine shut off switch to the On
position to start and operate the engine.
2. Set the engine shut off switch to the Off
position to shut off a running engine.
Recoil Starter
Start the engine with the recoil starter.
Oil Fill/Dipstick
Check the engine oil level (Figure 10).
Pin
Figure 8
Bushings
Pin
Bushings
Position wheel away from the blade
for bevel cutting or trimming.
Position wheel nearer the blade
for edging.
Throttle
Figure 9
Choke
Fuel Shut Off
Engine Shut Off
Switch
Recoil Starter