Owner`s manual

Page 36
Aries Spas • User Manual
yourpumphasnotpickedupprime,wait1hourandtryagaintorestore
prime.Ifyoustillcan’tstartcirculation,thencallAriesServiceDepart-
mentforadditionaltips.
Afterprimehasbeenrestored,resettheThermostattodesiredtempera-
turesetting.
The Filter Cartridge is very dirty.
DigitalReadoutmayread“FLO”.AcloggedFilterCartridgemaynot
allowwatertopassthroughtothespa.Toverifywhetherthisisyour
problem,removetheFilterCartridge,andresealyourlterwithoutthe
Cartridgeinside.Ifthewaternowcirculatesproperly,cleanyourFilter
Cartridgethoroughly,asexplainedin“Cleaningyourlter”.If,after
cleaning,itstillrestrictscirculation,ithasprobablybecomeheav-
ilyembeddedwithdebrisandoil.Itwillbenecessarytoreplacethe
Cartridge.
The Knife (“T” shaped) Valves may be partially or fully
closed, causing insufcient water ow (see “Filter
Cartridge is dirty” above).
DigitalReadoutmayread“FLO”.MakesurethatallKnifeValveson
eithersideoftheEquipmentPackarecompletelyopen(“T”pulled
fullyoutward),andrestartspa.
Water level in spa is below normal operating level, causing
insufcient water ow to heater
DigitalReadoutmayread“FLO”.Fillspatoappropriatelevel(toabout
themiddleofSkimmer)andrestart.
Internal “overtemp” switch may be tripped
DigitalReadoutmayread“OH”or“HL”.Donotenterwateruntilspa
hascooleddown.Ifthewatertemperatureintheheatertubegetstoo
hot(106˚spawater),thehighlimitswitchwilltripandturnoffthe
heaterandotheraccessoriestoprotectthespaequipmentfromover-
heating.Ifthisoccurs,“OH”isdisplayedalternatelywithtemperature
inthedigitalreadoutareaoftheTopsideControl.Whenthetempera-
turelowers,displaywillreturntonormalandtheheaterandother
accessorieswillbeenabled.