Owner`s manual

Page 42
Aries Spas • User Manual
Trouble Codes
IfyourcomputerizedEquipmentPacksensesaninternalproblem,itwill
putanerrorortroublecodeinthedigitalreadoutareaofyourTopside
Control.Followingarethemostcommonerrorcodes,andthesolutionfor
each.
3 Dashes on Digital Display
The digital display will show 3 dashes any time the power
to the system has been lost, then restored, The internal
clock cycle will reset. (None of your other settings will
have been changed.) The 3 dashes will remain while the
system purges, and will continue to display for about 1
minute longer, until system diagnostics have run.
“HR”
An internal hardware error has been detected in the
equipment. Contact an Aries Spa Technician.
“HL”
This appears when the spa’s water inside the equipment
has reached 119
o
. Do not enter the water! Remove the
spa cover and allow the water to cool down, then shut
power off and power your spa up again to reset the
system.
“AOH”
The temperature inside the spa skirt is too high, causing
the internal temperature in the equipment to increase
above normal limits. Open the skirt and wait until the error
clears.
“FLO”
The system does not detect any water ow while the
circulation pump is running. Check and open water valves
and jets, check that water is at appropriate level, clean the
lter. (See troubleshooting for additional information.)