Owner`s manual

Page 3
Aries Spas • User Manual
directionuntilhand-tight.(FormoreinformationontheBleedValve,see
the“TopLoadingPressureFilter”sectionofthismanual.)
TheCirculatingPumpmotorshouldstartrunningimmediately.Ifitdoes
not,recheckyourRockerSwitchsettingandtryagain.
OncetheCirculatingPumpmotorisrunningandwateriscirculating
properly,youshouldbeabletoobservewaterand/orbubblescoming
from the two CirculationJets(oneregular-sized,onesmall)usually
locatednearyourstepsand/orthelight.Thisindicatesthatthewateris
circulatingproperly.
Ifnowaterowisobserved,dothefollowing:
1. ListentomakesurethattheCirculatingPumpmotorisrun-
ning.
2. MakesurethattheKnife(“T”shaped)Valvesareopen.These
valves are plumbed into the pipes on either side of the equip-
mentpack.Theyareopenedifthehandlesareextendedasfar
outastheywillgo.
3. Recheck the BleedValveonthelterlidtomakesureyouhave
releasedalltrappedair.Sometimesdrainingasmallamountof
waterfromtheHoseBib(locatedbytheEquipmentPack)is
also helpful for releasingairlock.
Ifyouhavetriedalltheabove,andtherestillarenobubblescomingfrom
theCirculationJets,STOP! Turnoffthemainpowerswitch(pushthe
“Test”button)andcallusimmediately!Donotgoontothenextstepor
seriousdamagemayoccurtoyourspaequipmentpack.
OnceyouaresurethattheCirculatingPumpmotoriscirculatingthe
water,youarereadytoselecttheappropriateThermostatandTimeClock
settings,aslistedbelow.