Owner`s manual

Page 23
Aries Spas • User Manual
prime.Ifyoustillcan'tstartcirculation,thencallAriesServiceDepart-
ment for additional tips.
Afterprimehasbeenrestored,resetThermostattodesiredtemperature
setting.
The Filter Cartridge is very dirty.
AcloggedFilterCartridgemaynotallowwatertopassthroughtothe
spa.Toverifywhetherthisisyourproblem,removetheFilterCar-
tridge,andresealyourlterwithouttheCartridgeinside.Ifthewater
nowcirculatesproperly,cleanyourFilterCartridgethoroughly,as
explainedin“Cleaningyourlter”.If,aftercleaning,itstillrestricts
circulation,ithasprobablybecomeheavilyembeddedwithdebrisand
oil.ItwillbenecessarytoreplacetheCartridge.
Spa does not heat
The Filter Cartridge is dirty, causing insufcient water ow.
Whenyourheater’sinteriorowvalvesenseslowwaterow(thiscan
becausedbyacloggedFilterCartridge),itshutstheheateroffuntil
theowisagainsufcient(protectingyourheaterfromoverheating,
andpossiblyburningout).ThoroughlycleanyourFilterCartridgeand
restart the equipment.
The Knife (“T” shaped) Valves may be partially or fully
closed, causing insufcient water ow (see “Filter Cartridge
is dirty” above).
MakesurethatallKnifeValvesoneithersideoftheEquipmentPack
arecompletelyopen(“T”pulledfullyoutward),andrestartspa.
Water level in spa is below normal operating level, causing
insufcient water ow to heater (see “Filter Cartridge is
dirty” above).
Fillspatoappropriatelevel(toaboutthetopslitofSkimmer)and
restart.
“Limit Reset” Button may be tripped.
Resetyour“LimitReset”Buttonbypushing.Ifthespawaterorthe
outsidetemperatureisverywarm,youmayhavetowaitseveralhours