Owner`s manual

Page 2
Aries Spas • User Manual
Filling your Spa
Yourspashouldbelledwithwatertoapproximatelythebottomslitin
the skimmer(toidentify,seepictureofskimmerinthe“SuctionsFit-
tings”sectionofthismanual).Thewater level should never be below
theregularorwhirlingjets,butshouldnevercoveranyneck jets or the
recoveryjet(toidentify,seepicturesoftheabovementionedjetsin“Jets”
sectionofthismanual).Do not overll spa.
Starting your Circulating Pump
Beforeturningonyourhomecircuitbreaker,turnoffthemainpower
switch(theblackbuttonontheGFCI,locatedinthecenteroftheequip-
mentpack).
*If you do not see any switches or dials when looking at the
equipment pack, then simply pull open the swivel faceplate
covering the top portion of the equipment pack. (This is not
screwed into position, but simply held in place by a catch
resembling a screw.)
Also,makesurethatboththeThermostats(theoneonthetop-of-spa
locationandoneontheequipmentpack)areturnedtothe“off”position
orthelowestsettingpossible.
SettheRockerSwitchontheleftsideoftheequipmentpacktotheLow
SpeedMode(referto“EquipmentPackSettings”inthe“Operation”sec-
tion,ifnecessary).
Turnonyourhomecircuitbreaker.Turnonthemainpowerswitchby
pushingthered“Reset”buttonontheGFCI,locatedinthecenterofyour
equipment pack.
LifttheacryliclidthatcoversyourTopLoadingPressureFilter,andre-
leaseanytrappedairbyturningtheBleedValve(thesmallvalvelocated
onthelterlid)counterclockwiseuntilyouhearareleaseofair.Do not
totally unscrew or remove the Bleed Valve. Onceasteadystreamofwater
startsspurtingfromtheBleedValve,retightenbyturninginaclockwise