Owner`s manual

User Manual Aries Spas

Page

G.F.C.I. Breaker Reset Button

Your spa equipment pack is equipped with a G.F.C.I. breaker.

This breaker protects against accidental electrical shock caused by

water or excessive moisture on the electrical components.

To make sure that the G.F.C.I. breaker is operating properly, press

the black button labeled “Test”. If operating normally, the spa equip-

ment pack will shut off, and will require resetting. If water comes into

contact with the components, the black button will pop out. To reset,

push the red “reset” button. If the black button immediately pops out

again, wait a sufcient amount of time for the moisture to evaporate,

and try to reset again. If the black button continues to pop out, call

your spa dealer or the factory.

Overheat Protection Button

Your spa equipment pack is equipped with a heater overheat

sensor. This sensor protects your heater by turning off power to the

heater in cases where the water temperature in the heater have reached

a higher-than-normal condition. This can happen when your lter is

clogged or dirty enough to slow the water ow and trap water in the

heater for longer-than-normal periods of time.

If the Overheat Button pops out, thoroughly clean your lter to

restore maximum water ow before attempting to reset it, .

To reset, push the button inward. If it will not reset, wait until the

water inside the heater has had sufcient time to cool, then try again

to reset. (Depending on the outside temperature, this could take up to

several hours.)

Heater Indicator Light

This light illuminates any time the heater is operating.

Spa-side Controls

Single Function Controls

The following function buttons operate by pushing once to turn

on, and pushing again to turn off.

“Jets” Button

This button operates the water jets (ttings in the spa wall that

circulate the water into the spa under pressure). On systems with one

circulating pump and two high-speed pumps, several of the jets will be