Owner`s manual

User Manual Aries Spas
Page
“Rocker-Switch” settings above).
“Jets” Light
This light will illuminate when the high-speed jet pump has been
activated, using the “jet” button (above).
“Blower” Light
This light will illuminate when the air injector pump has been
activated, using the “blower” button (above).
Thermostat
If you have a spa-side thermostat, make sure that the thermostat
on your equipment pack is set to “Off”, or the minimum setting pos-
sible. Otherwise, malfunctions of both thermostats could occur.
The thermostat can be set to the desired temperature, within
a range from “Off” (no heat) through “Hot”. Set the thermostat to
“Warm” any time there is a possibility of freezing weather.
Initially, most people turn the thermostat to highest setting. After
the water has reached maximum temperature, using a spa thermom-
eter, the temperature can be gradually lowered by adjusting toward
cooler temperatures, as desired.
Interior Fittings
Venturi Controls (Air Controls)
Venturi controls are round knobs located on the “lip” or upper
ledge of your spa. Depending on the model, your spa may have one or
several venturis, each operating a certain number of jets. They control
the amount of air that is mixed with the water coming through the jets.
The air is pulled into the venturi by vacuum created from the rush of
water being forced through your spa’s jets while the jet pump is run-
ning.
To control the amount of air introduced into your jets, turn the
venturi knob to the desired setting, to any position from far left to far
right. For maximum jet pressure, turn the knob all the way to the left
(clockwise).
Circulation Fittings
The interior of your spa has two types of water ttings; suction
and return. The spa’s pump circulates your spa's water by pulling it
from the spa via suction ttings (top skimmer and bottom suction),
passing it through the heater and lter, then returning it to the spa via