Owner`s manual
Aries Spas User Manual
Page 22
After prime has been restored, reset thermostat to desired tem-
perature setting.
The lter is very dirty.
A clogged lter may not allow water to pass through to the spa.
To verify whether this is your problem, remove the lter cartridge,
and reseal your lter without the cartridge in place. If the water now
circulates properly, clean your lter cartridge thoroughly, as explained
in “Cleaning your lter”. If it restricts circulation after cleaning, it will
probably be necessary to replace the lter cartridge.
Spa does not heat
The lter is dirty, causing insufcient water ow.
When your heater’s ow valve senses low water ow (this can be
caused by a clogged lter), it shuts the heater off until the ow is again
sufcient (protecting your heater from overheating, and possibly burn-
ing out). Thoroughly clean your lter and restart the equipment.
If the spa is equipped with knife (“T” shaped) valves, they may be
partially or fully closed, causing insufcient water ow (see “Spa
does not heat” above).
Make sure that the knife valves on either side of the Equipment
Pack are completely open (“T” pulled fully outward), and restart spa.
Water level in spa is below normal operating level, causing
insufcient water ow (see “Filter is dirty” above).
Fill spa to appropriate level (approx. to top slit of skimmer) and
restart.
“Overheat Protection” button may be tripped.
Reset your “Overheat Protection” button. If the spa water or the
outside temperature is very warm, you may have to wait several hours
(overnight) for the water to cool sufciently to allow resetting.
Jet Pump does not work
Air hose that activates “Jet” button has come loose, either at back
of “Jet” button or at equipment pack
Make sure that air hose is attached rmly to back of “Jet” button
and to the tting on the equipment pack. Inspect the hose for visible
leaks or damage. If any are found, replace the air hose. Examine the
hose for obstructions, such as insects (re ants are a common culprit).
Clear any obstruction found.