Owner`s manual

Aries Spas User Manual
Page 6
Placement of Portable Spa
Electrical Hookup
Please refer to your equipment manual and contact a qualied
electrician. All spa equipment packs require a dedicated 60 amp, single
phase, 220 volt service, consisting of four wires. Any variation from
this service will void warranty.
Location.
It is very important that your spa be located on a solid, level
foundation.
A lled spa is very heavy (3,000 to 4000 lbs.), with most of the
weight resting on the center portion. Without rm support for the bot-
tom of the spa, settling can occur, causing the outside edge or “lip” of
the spa to carry the weight-load, pulling the spa out of shape. Cement
blocks are not acceptable, unless they are concreted into place.
Aries Spas will not be responsible for damages incurred on
spas placed on other than level, solid surfaces.
Operation
Initial Start-up
Please read this section fully before attempting initial
start-up of your spa.
Your spa should be lled with water to approximately the top slit
in the skimmer (see picture of skimmer in “Circulating ttings” be-
low).
Starting your IMS Motor
Before turning on your home circuit breaker, turn off the main
power switch (located in the lower right hand corner of the equipment
pack). Also, make sure that both the thermostats (one on the top-of-
the-spa location, and one on the equipment pack) are turned to the
“Heater System Control”