Owner`s manual

Aries Spas User Manual
Page 8
3. Open the air bleed valve on the lter lid to allow any trapped
air to escape. Re-close this valve as soon as water starts to ow
out of it.
If you have tried all the above, and there still are no bubbles com-
ing from the ozone and ozone recovery jets, STOP! Turn off the main
power switch and call us immediately! Do not go on to the next para-
graph or serious damage may occur to your spa equipment pack.
Once you are sure that the IMS motor is circulating the water, you
are ready to select the appropriate thermostat and TimeClock settings,
as listed below.
Equipment Pack Settings
Power Switch
The Power Switch is the main “On-Off” switch to the equipment
pack. In the “Off” position, the equipment pack cannot operate.
Rocker Switch Combinations
The following are combinations of the two Rocker Switches lo-
cated on your equipment pack. Choose the settings that best suits your
needs from the six combinations, listed below, .
IMS set to “Continuous”, Heating set to “Temperature Demand”
This is the recommended method of operating your spa year-
round.
With the IMS rocker switch set to “Continuous”, the low-speed
circulating pump continually circulates and lters the water. Also, if
your spa is equipped with an ozone generator (optional), the water will
be more thoroughly ozone-charged.
And with the Heater rocker switch set to “Temperature Demand”
the heater will cycle on and off, holding the water at the temperature
you desire (see “Setting the Thermostat” below).
IMS set to “Continuous”, Heating set to “Off (center position)”
This setting can be used during mild weather, when the spa will
not be used for an extended period of time, or during summer months,
if a “cool-pool” situation is desired. Do not use this setting if there is a
possibility of freezing temperatures, as the heater is not able to oper-
ate in this setting, and water in the equipment could freeze and cause
damage to your equipment pack!
With the IMS rocker switch set to “Continuous” the low-speed
circulating pump continually circulates and lters the water, as above.
Make sure that the
knife ("T" shaped)
valves are open,
or serious damage
could result.