User Manual

ManualsBrandsAries Automotive ManualsCar1043

PARTS LIST:

Qty Description Qty Description

1 Grille Guard 2 Square Tube Spacers

1 Driver/Left Lower Mounting Bracket 10 10-1.5mm x 30mm Hex Head Bolts

1 Passenger/Right Lower Mounting Bracket 22 10mm ID x 25mm OD x 2.5mm Flat Washers

2 Driver/Passenger Support C Bracket 10 10mm Hex Nuts

1 Driver/Left Upper Brace Bracket 12 10mm Lock Washers

1 Passenger/Right Upper Brace Bracket 2 10-1.5mm x 60mm Hex Head Bolts

Page 1 of 4

INSTALLATION INSTRUCTIONS

1986-2000 JEEP CHEROKEE/SPORT (Does not fit limited)

PART# 1043

Passenger/right side

Upper Brace Bracket

Passenger/right side

Lower Mounting Bracket

Driver/left side Upper

Brace Bracket

Driver/Passenger

Support C Bracket

Driver/left side Lower

Mounting Bracket

Square Tube Spacers

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS 1986-2000 JEEP CHEROKEE/SPORT (Does not fit limited) PART# 1043 PARTS LIST: Qty 1 1 1 2 1 1 Description Grille Guard Driver/Left Lower Mounting Bracket Passenger/Right Lower Mounting Bracket Driver/Passenger Support C Bracket Driver/Left Upper Brace Bracket Passenger/Right Upper Brace Bracket Driver/left side Lower Mounting Bracket Qty 2 10 22 10 12 2 Description Square Tube Spacers 10-1.5mm x 30mm Hex Head Bolts 10mm ID x 25mm OD x 2.
PAGE 2
PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED. 2. Starting from under the front bumper, carefully remove the (2) push pins securing the plastic valance, (Fig 1). NOTE: Depending on the year and model of vehicle, there may be several two-piece plastic push-in clips holding the valance up to the vehicles bumper. Pry the pins up with a small flat blade screwdriver to release and remove the entire clip.
PAGE 3
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the Grille Guard. For gloss black finishes: Mild soap may be used to clean the Grille Guard.
PAGE 4
PASSENGER SIDE INSTALLATION PICTURED Fig 4 Fig 5 Support C bracket Upper brace bracket (2) 10mm x 30mm hex bolts (4) 10mm flat washers (2) 10mm lock washers (2) 10mm hex nuts Fig 6 Front Fig 7 (2) 10mm x 30mm hex bolts (4) 10mm flat washers (2) 10mm lock washers (2) 10mm hex nuts (1) 10mm x 30mm hex bolts (2) 10mm flat washers (1) 10mm lock washers (1) 10mm hex nuts Front Page 4 of 4