Installation Guide

ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
87 7. 2 8 7. 8 6 3 4
•
15911-INS-RC
•
PAGE 2
Step 1
Starting on the driver side, use a ratchet and
a T-50 Torx bit to remove the top five factory
fasteners from the windshield pillar.
Step 2
Select the driver-side mounting bracket and
install using the provided M8 x 35mm button
head screw, M8 flat washer and spacer.
Once the spacers are between the mounting
bracket and vehicle, start all five screws.
Snug the hardware, but do not fully tighten.
Note: To make the installation of the spacers
between the bracket and vehicle easier, apply
a small amount of adhesive to the spacers and
temporarily secure them to the vehicle over the
mounting locations.
Repeat this process to attach the
passenger-side bracket to the vehicle.