Owners manual

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 15911-INS-RA • PAGE 2
Step 2
Select the driver-side mounting
bracket and install using the provided
M8 x 35mm button head screw,
M8 flat washer and spacer.
Once the spacers are between
the mounting bracket and vehicle,
start all five screws.
Snug the hardware,
but do not fully tighten.
Note: To make the installation of
the spacers between the bracket
and vehicle easier, apply a small
amount of adhesive to the spacers
and temporarily secure them to the
vehicle over the mounting locations.
Repeat this process to attach the
passenger-side bracket to the vehicle.
Step 1
Starting on the drivers side,
use a ratchet and a T-50 Torx bit to
remove the top five factory fasteners
from the windshield pillar.