Owners manual

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2072101-INS-RA • PAGE 4
Step 9
Tuck the fog light wiring harness
into the frame channel.
Insert a nut plate, aligning the two
threaded holes with the holes in
the Jeep frame. Temporarily hold
in place with tape.
Repeat this process on the driver side.
Step 8
Pull out the wiring harness from
the side of the frame and place
tape on the nut plates.
Step 7
Cut off the vacuum bracket as shown
and deburr the cut edge. Use touch up
paint to protect raw metal.