Owners manual

PAGE 1 • 2074100-INS-RB • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM

Product Image

Level of Difﬁculty

Easy

Scan

for helpful

install tips

INSTALLATION MANUAL 2074100

Tools Required

Ratchet Extension

Socket, 10mm Socket, 16mm

Wrench, 10mm Flathead

screwdriver

Parts List

1 Driver / left rocker step

1 Passenger / left rocker step

4 Hex bolt, 6mm

8 Flat washer, 6mm

4 Nylock nut, 6mm

4 Hex bolt, 8mm

4 Flat washer, 8mm

4 Lock washer, 8mm

4 Hex bolt, 10mm

4 Flat washer, 10mm

4 Lock washer, 10mm

4 Nut plate, 10mm

Notes and Maintenance

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of installation and reduce the time required.

For black ﬁnishes, mild soap may be used to clean the product.

PAGE 1
INSTALLATION MANUAL Parts List Level of Difficulty 1 Driver / left rocker step Easy 1 Passenger / left rocker step 4 Hex bolt, 6mm 8 Flat washer, 6mm 4 Nylock nut, 6mm 4 Hex bolt, 8mm 4 Flat washer, 8mm 4 Lock washer, 8mm 4 Hex bolt, 10mm 4 Flat washer, 10mm 4 Lock washer, 10mm 4 Nut plate, 10mm 2074100 Scan for helpful install tips Product Image Notes and Maintenance Tools Required Before you begin installation, read all instructions thoroughly.
PAGE 2
Step 1 Locate the two mounting points along the bottom edge of the vehicle body. Step 2 Starting on the driver side, locate the front mounting point. Insert a 10mm nut plate into the opening, aligning it over the mounting hole. On newer vehicles the mounting hole is supplied with a threaded fastener and the bolt plate is not required. Note: There may be tape covering the mounting hole. Step 3 At the rear mounting point, repeat step 2.
PAGE 3
Step 5 Secure the rocker step rear attachment point with a 10mm hex bolt, lock washer and flat washer into the nut plate. If the vehicle has factory threads, secure with the supplied 8mm hex nut, lock washer and flat washer. Secure the rocker step front attachment point by inserting a 6mm hex bolt and flat washer on the outside, along with a flat washer and nylon lock nut on the inside. Step 6 Repeat step 5 for the rear attachment point to finish the installation process for the driver side rocker step.